The Processing Controller is launched from the main SNP window. It consists of a number of tabs that should be worked through consecutively. However some iteration will generally be required to optimise the calibration.
Open new project or existing project
Select input horizons attributes
Specify inline and crossline range
Flag if reservoir is high or low impedance
Load horizon data and generate maps and cross-plots
Specify filter parameters and maximum reservoir thickness (ms)
Specify self-calibration scaling value and dt range
Specify pay/non-pay velocity ratio and apply correction
Specify net-to-gross range and calculate net pay attributes
Input well data – inline, crossline and net pay values
Generate net pay crossplots
Adjust well locations and/or adjust calibration scalar (loop to step 7)
When calibration is optimised select output horizons
Save data and exit
Refer to SNP Program Description for further information of each of these steps.
Copyright Notice and Disclaimer
SnpQt Application (the “Software”)
© 2014 ARK CLS Limited. All rights reserved.
© 2004 BP Exploration Operating Company Limited. All rights reserved.
BP assumes no responsibility for errors or omissions in the Software and/or related documentation. BP makes no representation or warranty about the performance and/or functionality of the Software and related documentation. All such Software and related documentation are provided “as is” without warranty of any kind, either express or implied, including without limitation the implied warranties of merchantability, fitness for a particular purpose and non-infringement. In no event shall BP be liable for any special, indirect, incidental or consequential damages that may result from the use of the Software and/or related documentation.